AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Moku hanga carving tools5/1/2023 ![]() Laura Boswell recommends that two lots of five pages of newspaper be used as a buffer with individual sheets of paper laid alternatively between single sheets of newspaper. The proofing/printing paper has to be dampened before printing can take place. Any excess ink that drains into the moat can be removed before printing. The moat is achieved by removing approximately a 3cm width of wood. The angle of the knife blade creates a slope away from the image so that the ink drains into the moat rather than ponding next to, what would have been, a right-angled cut. I could the start carving around each drawing using the knife (Hangi-Toh). The traced drawing is transferred to the appropriate block using carbon paper, taking care to position the kento marks in exactly the correct position. ![]() Each block required kento marks to aid registration. As can be seen from the images below, some of the blocks were positioned on the same piece of Asian plywood. This would equate to six blocks, one for each colour. Having traced the image from one of my holiday photographs, I decided that I would need six colours. U- and V-Profile Gouges plus Hangi-Toh Knife and Chiselįor an in-depth look at materials and techniques, Vollmer (2015) is an excellent resource.Nori paste: a mixture of rice powder and water carried to the block using wooden cocktail sticks.Barren: I used a plastic disk barren with small raised dots underneath.Inks: a selection of tube-based inks diluted with water.Brushes: a selection of Japanese printing brushes, paint brushes for carrying ink and a wallpaper paste brush for water carrying (for dampening the printing paper). ![]()
0 Comments
Read More
Leave a Reply. |